Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Multi-display) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261004 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display)  Rear Clearance Sonar Sensor RH Circuit  


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance between the vehicle and obstacle and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM

E132021E35
4.38,1.995 4.689,2.193 0.309,0.198 10 U5 4.38,2.133 6.020,2.485 1.639,0.351 10 No. 1 Ultrasonic Sensor (Rear Corner Sensor RH) 1.065,1.983 1.374,2.180 0.309,0.198 10 U4 1.062,2.145 2.730,2.495 1.668,0.350 10 No. 1 Ultrasonic Sensor (Rear Center Sensor RH) 2.161,1.636 2.535,1.851 0.373,0.215 10 EO 2.161,1.253 2.535,1.468 0.373,0.215 10 SO 4.824,0.815 5.141,1.013 0.317,0.199 10 BI 4.828,1.636 5.202,1.851 0.373,0.215 10 EI 4.828,1.253 5.202,1.468 0.373,0.215 10 SI 2.157,0.815 2.474,1.013 0.317,0.199 10 BO 2.498,0.74 2.592,0.926 0.095,0.186 10 2 2.498,1.146 2.605,1.316 0.107,0.170 10 4 4.609,1.52 4.707,1.671 0.098,0.151 10 5 4.599,0.74 4.694,0.926 0.095,0.186 10 1 4.599,1.146 4.707,1.316 0.107,0.170 10 3 2.507,1.52 2.605,1.671 0.098,0.151 10 6

PROCEDURE

1.REPLACE NO. 1 ULTRASONIC SENSOR (REAR CORNER SENSOR RH)
a.

Replace the No. 1 ultrasonic sensor with a normally functioning sensor (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Rear)>REMOVAL).



NEXT

2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - REAR CENTER SENSOR RH)
2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - REAR CENTER SENSOR RH)
a.

Disconnect the U5 No. 1 clearance sensor (rear corner sensor RH) connector.


b.

Disconnect the U4 No. 1 clearance sensor (rear center sensor RH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U5-1 (BI) - U4-2 (BO) Always Below 1 Ω
U5-3 (SI) - U4-4 (SO) Always Below 1 Ω
U5-5 (EI) - U4-6 (EO) Always Below 1 Ω
U5-1 (BI) - Body ground Always 10 kΩ or higher
U5-3 (SI) - Body ground Always 10 kΩ or higher
U5-5 (EI) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR