Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM (w/o Multi-display) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261004 TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display) J

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM(w/o Multi-display)  Clearance Warning ECU Power Source Circuit  


DESCRIPTION

This circuit is the power source circuit used to operate the clearance warning ECU.

WIRING DIAGRAM

E172196E16
0.406,0.479 1.656,0.646 1.25,0.167 10 false from Ignition Switch 3.354,0.656 4.271,0.823 0.917,0.167 10 false ECU-IG NO. 2 5.594,0.458 5.802,0.625 0.208,0.167 10 false IG 5.594,1.281 5.802,1.448 0.208,0.167 10 false E 5.469,1.802 5.865,1.969 0.396,0.167 10 false I1 5.469,2.01 7.01,2.344 1.542,0.333 10 false Clearance Warning ECU 5.302,0.344 5.51,0.51 0.208,0.167 10 false 10 5.302,1.156 5.51,1.323 0.208,0.167 10 false 21

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BATTERY AND BODY GROUND)
a.
U147936E03
1.01,1.458 0.844,1.708 0.844,1.708 0.656,1.719 false 2.135,1.458 2.396,1.708 2.396,1.708 2.625,1.719 false 0.031,0 0.24,0.167 0.208,0.167 10 false *a 1.698,0.729 1.844,0.896 0.146,0.167 10 false I1 0.427,1.625 0.635,1.792 0.208,0.167 10 false IG 2.667,1.635 2.875,1.802 0.208,0.167 10 false E

Disconnect the I1 clearance warning ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I1-10 (IG) - Body ground Ignition switch ON 11 to 14 V
I1-10 (IG) - Body ground Ignition switch off Below 1 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I1-21 (E) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU)


OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR