Turn the light control switch to the TAIL position.
Check that the taillight turns on.
Taillight turns on.
OK
NG
Disconnect the I1 clearance warning ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I1-11 (TL) - Body ground | Ignition switch ON, light control switch TAIL | 7 V or higher |
| Ignition switch ON, light control switch not TAIL | Below 1.5 V |
| *a | Front view of wire harness connector
(to Clearance Warning ECU) |
OK
NG