This circuit provides power to operate the clearance warning ECU.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the clearance warning ECU connector.
Measure the voltage according to the value(s) on the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I1-15 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| I1-15 (IG) - Body ground | Engine switch off | Below 1 V |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G154-15 (IG) - Body ground | Engine switch on (IG) | 11 to 14 V |
| G154-15 (IG) - Body ground | Engine switch off | Below 1 V |
| *A | for 4 Sensor Type |
| *B | for 8 Sensor Type |
| *a | Front view of wire harness connector
(to Clearance Warning ECU) |
OK
NG
Disconnect the clearance warning ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I1-17 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G154-17 (E) - Body ground | Always | Below 1 Ω |
| *A | for 4 Sensor Type |
| *B | for 8 Sensor Type |
| *a | Front view of wire harness connector
(to Clearance Warning ECU) |
OK
NG