CHECK DTC
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the blind spot monitor main switch assembly (multi-function switch) on.
Turn the GTS on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
The blind spot monitor sensor RH and the blind spot monitor sensor LH both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.
Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
CLEAR DTC
Connect the GTS to the DLC3.
Turn the engine switch on (IG).
Turn the blind spot monitor main switch assembly (multi-function switch) on.
Turn the GTS on.
Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
Clear the DTCs.