Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU) › 2015.06–2017.08
RM27T0E _56 Audio / Visual / Telematics _053722 PARK ASSIST / MONITORING _0261016 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0140  Lost Communication with Body Control Module  U0163  Lost Communication with Navigation Control Module  U1110  Lost Communication with Intuitive Parking Assist Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the rear television camera assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC Code DTC Detection Condition Trouble Area
U0100 Lost communication with ECM CAN communication system
U0126 Lost communication with spiral with cable sensor sub-assembly
U0140 Lost communication with main body ECU (multiplex network body ECU)
U0163 Lost communication with radio and display receiver assembly (for Navigation Receiver Type) or radio and display receiver assembly (for Radio and Display Type)
U1110 Lost communication with clearance warning ECU assembly (w/ TOYOTA Parking Assist-sensor System)

PROCEDURE

1.CHECK DTC OUTPUT

b.

Check for DTCs and check that no DTCs are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM (for Camera built-in ECU)>DTC CHECK / CLEAR).

HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).




Result
Result Proceed to
DTCs U0100, U0126, U0140, U0163 and U1110 are not output A
DTCs U0100, U0126, U0140, U0163 and/or U1110 is output B


A

B