Home › Power Source / Network › 5L-E (BATTERY / CHARGING) › GENERATOR
RM27T0E _57 Power Source / Network _053723 5L-E BATTERY / CHARGING _0261017 GENERATOR A

5L-E BATTERY / CHARGING  GENERATOR  REASSEMBLY  


PROCEDURE

Hide 27330 1.INSTALL GENERATOR ROTOR ASSEMBLY

a.
A225703E01
0.671,0.18 0.994,0.336 0.323,0.156 10 SST 1.497,0.583 1.185,0.265 1.185,0.265 1.054,0.265 false

Using SST and a press, press in the generator rotor.

SST
09285-76010  


b.

Place the washer on the generator rotor.


Hide 27359 2.INSTALL GENERATOR RECTIFIER END FRAME

a.
A220286E01
2.622,0.252 2.807,0.405 0.185,0.153 10 *1 1.891,0.792 2.508,0.343 2.508,0.343 2.617,0.343 false

Using a 17 mm socket wrench and press, slowly press on the rectifier end frame.

Text in Illustration
*1 17 mm Socket Wrench


b.

Install the cord clip and 4 nuts.

Torque:
5.9 N*m (60 kgf*cm, 52 in.*lbf)


Hide 27357 3.INSTALL GENERATOR HOLDER WITH RECTIFIER

a.
A220287

Install the 4 rubber insulators to the lead wires.

Text in Illustration
V100135

Inside

NOTICE:

Be careful to install the rubber insulators in the correct direction.



b.
A220288

While pushing down on the rectifier holder, install it with the 4 screws.

Torque:
2.9 N*m (30 kgf*cm, 26 in.*lbf)

Text in Illustration
V100135

Push


Hide 27700A 4.INSTALL GENERATOR REGULATOR ASSEMBLY

a.

Install the regulator with the 3 screws.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)


Hide 27370 5.INSTALL GENERATOR BRUSH HOLDER ASSEMBLY

a.

Install the plate seal.


b.
A220289

Install the brush holder with the 2 screws.

Torque:
2.0 N*m (20 kgf*cm, 18 in.*lbf)

Text in Illustration
V100135

Upper


c.

Install the brush holder cover.


Hide 27039 6.INSTALL GENERATOR REAR END COVER

a.
A220290E01
2.432,0.212 2.611,0.373 0.179,0.161 10 *1 2.818,0.658 2.704,0.308 2.704,0.308 2.639,0.308 false

Install the rear end cover and rectifier plate with the bolt and 3 nuts.

Torque:
for nut : 4.4 N*m (45 kgf*cm, 39 in.*lbf)
for bolt : 3.9 N*m (40 kgf*cm, 35 in.*lbf)

Text in Illustration
*1 Rectifier Plate


b.

Install the terminal insulator with the nut.

Torque:
4.1 N*m (42 kgf*cm, 36 in.*lbf)


Hide 29300 7.INSTALL VACUUM PUMP ASSEMBLY

a.

Align the matchmarks and install the vacuum pump with the 4 bolts.

Torque:
7.8 N*m (80 kgf*cm, 69 in.*lbf)