Home › Power Source / Network › 2TR-FE (BATTERY / CHARGING) › GENERATOR
RM27T0E _57 Power Source / Network _053725 2TR-FE BATTERY / CHARGING _0261021 GENERATOR G

2TR-FE BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27415 1.INSPECT GENERATOR WITH CLUTCH PULLEY

a.
A222452

Hold the center of the generator pulley with clutch and confirm that the outer ring turns counterclockwise and does not turn clockwise.

Text in Illustration
V100135

Free
V100136

Lock

If the result is not as specified, replace the generator pulley with clutch.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A284139E01
0.639,0.711 0.860,0.885 0.221,0.174 10 *a

Using a vernier caliper, measure the exposed brush length.

Standard exposed brush length:

9.5 to 11.5 mm (0.374 to 0.453 in.)


Minimum exposed brush length:

4.5 mm (0.177 in.)


Text in Illustration
*a Length

If the exposed brush length is less than the minimum, replace the generator brush holder assembly.


Hide 27330 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A298011

Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.

If necessary, replace the generator rotor assembly.


b.

Check the generator rotor assembly for an open circuit.

i.
A153720E02
1.76,1.042 2.365,0.656 2.365,0.656 1.896,1.104 true 2.375,0.531 2.563,0.708 0.188,0.177 10 false *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 1.8 to 2.2 Ω


Text in Illustration
*a Slip Ring

If the result is not as specified, replace the generator rotor assembly.



c.

Check the generator rotor assembly for a short to ground.

i.
A153814E04
2.479,0.979 2.354,0.979 2.354,0.979 2.042,1.344 true 2.052,0.198 1.927,0.198 1.927,0.198 1.25,1.021 true 2.51,0.885 2.688,1.052 0.177,0.167 10 false *a 2.063,0.104 2.24,0.271 0.177,0.167 10 false *b

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Rotor core Always 10 MΩ or higher


Text in Illustration
*a Slip Ring
*b Rotor Core

If the result is not as specified, replace the generator rotor assembly.



d.

Check each slip ring.

i.

Check that the slip rings are not rough or scored.

If the slip rings are rough or scored, replace the generator rotor assembly.


ii.
A182587E01
0.545,0.548 0.701,0.730 0.156,0.181 10 *a

Using a vernier caliper, measure the slip ring diameter.

Standard diameter:

14.2 to 14.8 mm (0.559 to 0.583 in.)


Minimum diameter:

14.0 mm (0.551 in.)


Text in Illustration
*a Diameter

If the diameter is less than the minimum, replace the generator rotor assembly.