Home › Power Source / Network › 1KD-FTV (BATTERY / CHARGING) › GENERATOR › 2015.06–2020.08
RM27T0E _57 Power Source / Network _053726 1KD-FTV BATTERY / CHARGING _0261023 GENERATOR G

1KD-FTV BATTERY / CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27415 1.INSPECT GENERATOR WITH CLUTCH PULLEY

a.
A226388

Hold the center of the generator with clutch pulley, and confirm that the outer ring turns counterclockwise and does not turn clockwise.

Text in Illustration
V100135

Free
V100136

Lock

If the result is not as specified, replace the generator with clutch pulley.


Hide 27370 2.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A113754E04
0.692,0.672 0.872,0.836 0.180,0.164 10 *1

Using a vernier caliper, measure the brush length.

Standard length:

9.5 mm to 11.5 mm (0.374 to 0.453 in.)


Minimum length:

4.5 mm (0.177 in.)


Text in Illustration
*1 Length

If the length is less than the minimum, replace the brush holder assembly.


Hide 27330 3.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A079306

Inspect that the bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


b.
B012264E26
1.585,0.07 1.813,0.232 0.228,0.163 10 *1 0.355,1.134 0.487,0.143 0.487,0.143 1.49,0.143 false 0.458,1.066 0.487,0.143 false

Check the rotor for an open circuit.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (68°F) 2.3 to 2.7 Ω


Text in Illustration
*1 Slip Ring

If the result is not as specified, replace the generator rotor assembly.



c.
B012265E21
1.702,0.325 1.862,0.490 0.161,0.165 10 *1 1.633,0.423 1.547,0.423 1.547,0.423 1.318,0.732 false 0.43,1.162 0.799,1.531 0.799,1.531 1.031,1.531 false 1.089,1.454 1.268,1.614 0.179,0.161 10 *2

Check if the rotor is grounded.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Rotor - Slip ring Always 10 kΩ or higher


Text in Illustration
*1 Slip Ring
*2 Rotor Core

If the result is not as specified, replace the generator rotor assembly.



d.
B012266

Using a vernier caliper, measure each slip ring diameter.

Standard diameter:

14.2 to 14.4 mm (0.559 to 0.567 in.)


Minimum diameter:

14.0 mm (0.551 in.)


If either diameter is less than the minimum, replace the rotor.