This DTC is output when LIN communication between the certification ECU and ID code box stops for 10 seconds or more.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2789 | No communication between the certification ECU and ID code box for 10 seconds or more. | ·
ID code box ·
Certification ECU ·
Harness or connector |
When using the intelligent tester with the ignition switch off to troubleshoot:
Connect the intelligent tester to the vehicle and turn a courtesy light switch on and off at 1.5 second intervals until communication between the intelligent tester and vehicle begins.
Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure.
When communication between the ID code box and certification ECU stops, DTC B2785 is also stored.
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B2789 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG
Disconnect the G38 certification ECU connector.
Disconnect the G37 ID code box connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G38-29 (LIN) - G37-3 (LIN1) | Always | Below 1 Ω |
| G38-29 (LIN) or G37-3 (LIN1) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the G37 ID code box connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-8 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-1 (+B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to ID Code Box) |
OK
NG
Temporarily replace the ID code box with a new one.
NEXT
Clear the DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
NEXT
Check for DTCs (See page Power Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR).
DTC B2789 is not output.
OK
NG