| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Skid Control ECU Communication Stop Mode | Either condition is met:
·
"Skid Control (ABS/VSC/TRAC)" is not displayed on "Bus Check". ·
"Skid Control ECU Communication Stop Mode" in "DTC Combination Table" applies. |
·
Power source or inside master cylinder solenoid (skid control ECU) ·
Master cylinder solenoid (skid control ECU) branch wire or connector ·
Master cylinder solenoid (skid control ECU) |
For vehicles with a 1GR-FE, 1KD-FTV, 1GD-FTV engine.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Operating the engine switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the CAN main wire and the CAN branch wire.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the airbag system.
After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
NEXT
Disconnect the A7 master cylinder solenoid (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A7-11 (CANH) - A7-25 (CANL) | Engine switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Master Cylinder Solenoid [Skid Control ECU]) |
OK
NG
Connect the cable to the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
Disconnect the A8 master cylinder solenoid (skid control ECU) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-1 (GND1) - Body ground | Always | Below 1 Ω |
| A7-32 (GND2) - Body ground | Always | Below 1 Ω |
| A8-4 (GND3) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A7-2 (+BM1) - Body ground | Always | 11 to 14 V |
| A8-2 (+BM2) - Body ground | Always | 11 to 14 V |
| A7-31 (+BS) - Body ground | Always | 11 to 14 V |
| A8-1 (IG2) - Body ground | Engine switch on (IG) | 11 to 14 V |
| *a | Front view of wire harness connector
(to Master Cylinder Solenoid [Skid Control ECU]) |
OK
NG