Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER(w/o Entry and Start System) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053730 DOOR LOCK _0261046 DOOR CONTROL TRANSMITTER(w/o Entry and Start System) A

DOOR LOCK  DOOR CONTROL TRANSMITTER(w/o Entry and Start System)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

Take extra care when handling these precision electronic components.


PROCEDURE

Hide 89745A 1.INSTALL TRANSMITTER BATTERY (except Separate Type)

NOTICE:

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.


a.
B102768

Install the battery (lithium battery: CR2016) with the positive (+) side facing upward as shown in the illustration.

NOTICE:
·

Be careful not to bend the transmitter battery electrode during insertion.

·

Keep the transmitter cover interior free of dust and oil.




b.

Install the cover.


Hide 89071B 2.INSTALL DOOR CONTROL TRANSMITTER MODULE (except Separate Type)

a.

Install the door control transmitter module.


Hide 89751A 3.INSTALL TRANSMITTER HOUSING COVER (except Separate Type)

a.

Install the transmitter housing cover to the transmitter housing case.


b.

Check that the transmitter LED illuminates 3 times when a switch is pressed 3 times.


Hide 89745A 4.INSTALL TRANSMITTER BATTERY (for Separate Type)

NOTICE:

When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the door control transmitter module set from being damaged.


a.
B239792

Install a new battery (lithium battery: CR2032) with the positive (+) side facing upward as shown in the illustration.

NOTICE:
·

Do not bend the transmitter battery electrode during insertion.

·

Keep the transmitter cover interior free of dust and oil.




b.

Install the transmitter housing cover.


c.

Press one of the transmitter switches and check that the LED illuminates.