Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261052 ENTRY AND START SYSTEM(for Start Function) C

THEFT DETERRENT / KEYLESS ENTRY  ENTRY AND START SYSTEM(for Start Function)  U0100  Lost Communication with ECM / PCM  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Main Body ECU  U0155  Lost Communication with Combination Meter  


DESCRIPTION

The power management control ECU receives information from 2 sources. It receives information via a direct line and via the CAN communication line. If the information from these 2 sources is inconsistent, this DTC is stored.

HINT:

When the power management control ECU is replaced with a new one and the cable is connected to the negative (-) battery terminal, the power source mode is reset to on (IG). When the battery is removed and reinstalled, the power source mode that was selected when the battery was removed is restored.


DTC Code DTC Detection Condition Trouble Area
U0100 There is no communication from the ECM.
·

CAN communication system

·

ECM


U0129 There is no communication from the skid control ECU.
·

CAN communication system

·

Skid control ECU


U0142 There is no communication from the main body ECU.
·

CAN communication system

·

Main body ECU (Driver side junction block assembly)


U0155 There is no communication from the combination meter.
·

CAN communication system

·

Combination meter assembly



PROCEDURE

1.CHECK FOR DTC


c.

Recheck for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>DTC CHECK / CLEAR).

Result
Result Proceed to
DTC is not output A
DTC is output for LHD with Entry and Start System B
for RHD with Entry and Start System C



A

B

C