This circuit provides power to operate the ID code box.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G37 box connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-1 (+B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G37-8 (GND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to ID Code Box) |
OK
NG