81260A
1.REMOVE MAP LIGHT ASSEMBLY
89732
2.REMOVE THEFT WARNING RADAR SENSOR
Disconnect the connector.
Remove all the tape and the 2 screws.
Detach the clamp and disconnect the central part of the theft warning radar sensor.
Using a thin-bladed screwdriver, push the bezel down lightly.
Perform the same procedure on the other side.
Tape the screwdriver tip before use.
Insert the thin-bladed screwdriver into the cutout portion of the bezel and remove the bezel from the map light.
Perform the same procedure on the other side.
Tape the screwdriver tip before use.
Disconnect the 2 connectors.
Remove the 2 screws and theft warning radar sensor.
Perform the same procedure on the other side.