Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)
RM27T0E _58 Vehicle Interior _053731 THEFT DETERRENT / KEYLESS ENTRY _0261067 ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System) C

THEFT DETERRENT / KEYLESS ENTRY  ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)  B2795  Unmatched Key Code  


DESCRIPTION

This DTC is stored when a key with a different vehicle serial number is inserted into the ignition key cylinder.

DTC No. DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B2795 A key with a different vehicle serial number is inserted into the ignition key cylinder (1 trip detection logic*).
·

Key

·

Transponder key ECU assembly


Insert the key into the ignition key cylinder.

*: Only output while a malfunction is present.

Vehicle Condition and Fail-safe Operation when Malfunction Detected
Vehicle Condition when Malfunction Detected Fail-safe Operation when Malfunction Detected
Engine cannot be started -

Related Data List and Active Test Items
DTC No. Data List and Active Test
B2795 -

CAUTION / NOTICE / HINT

NOTICE:
·

If the transponder key ECU assembly or key is replaced, refer to the Service Bulletin.

·

After repair, confirm that no DTCs are output by performing "DTC Output Confirmation Operation".

·

When using the GTS with the vehicle ignition switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Immobiliser. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.



PROCEDURE

2.CHECK FOR DTC
a.

Insert and remove each registered key one at a time, and check for DTCs each time (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM(w/o Entry and Start System)>DTC CHECK / CLEAR).

HINT:
·

Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.

·

If DTC B2795 is stored, check for DTCs with the next key after clearing the DTCs.



OK:

DTC B2795 is not output.


Result
Result Proceed to
DTC B2795 is not output A
DTC B2795 is output for all of the keys B
DTC B2795 is output for any of the keys C



A

B

REPLACE TRANSPONDER KEY ECU ASSEMBLY

C

3.CHECK OPERATION (IG ON)
3.CHECK OPERATION (IG ON)
a.

Check that the ignition switch can be turned to ON using the key for which the DTC was stored.

OK:

Ignition switch can be turned to ON using the key (for which the DTC was stored).




OK

4.REREGISTRATION

NG

REPLACE KEY FOR WHICH DTC WAS OUTPUT

4.REREGISTRATION

b.

Reregister the key ID code with the transponder key ECU assembly.

OK:

Registration procedure can be completed.




OK

END (KEY REGISTRATION FAILURE)

NG

REPLACE KEY FOR WHICH DTC WAS OUTPUT