81260A
1.INSPECT MAP LIGHT ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 21 (+B1) - 15 (GND1) | Spot light switch off | 10 kΩ or higher |
| Spot light switch on | Below 1 Ω | |
| 21 (+B1) - 1 (CTY) | Not door position | 10 kΩ or higher |
| Door position | Below 1 Ω |
If the result is not as specified, replace the map light assembly.
| *a | Component without harness connected
(Map Light Assembly) |