84160
1.INSPECT ROOM LIGHT SWITCH ASSEMBLY
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (UP) - 4 (E) | Light control switch off | 10 kΩ or higher |
| Light control switch UP | Below 1 Ω | |
| 2 (DOWN) - 4 (E) | Light control switch off | 10 kΩ or higher |
| Light control switch DOWN | Below 1 Ω |
Apply battery voltage to the connector and check the LED illumination.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 1 (E) |
LED illuminates |
If the result is not as specified, replace the room light switch assembly.
| *a | Component without harness connected
(Room Light Switch) |