Home › Vehicle Interior › LIGHTING (INT) › RELAY
RM27T0E _58 Vehicle Interior _053732 LIGHTING (INT) _0261080 RELAY G

LIGHTING (INT)  RELAY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 28300 1.INSPECT LIGHT CUT RELAY

E284285

a.

Remove the light cut relay from the engine room relay box.


b.
E256070E05
2.917,1.396 3.01,1.396 false 2.281,1.396 2.365,1.396 false 2.677,0.656 2.771,0.75 false 2.49,0.771 2.625,0.896 false 2.375,1.302 2.51,1.458 0.135,0.156 10 false 2 2.813,1.302 2.948,1.458 0.135,0.156 10 false 1 2.813,0.677 2.948,0.833 0.135,0.156 10 false 3 2.396,0.677 2.531,0.833 0.135,0.156 10 false 5 1.552,1.354 1.688,1.51 0.135,0.156 10 false 2 0.281,1.354 0.417,1.51 0.135,0.156 10 false 1 0.281,0.646 0.417,0.802 0.135,0.156 10 false 3 1.552,0.854 1.688,1.01 0.135,0.156 10 false 5

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
3 - 5 Battery voltage not applied to terminals 1 and 2 10 kΩ or higher
Battery voltage applied to terminals 1 and 2 Below 1 Ω


If the result is not as specified, replace the light cut relay.


c.

Install the light cut relay to the engine room relay box.