METER GAUGE AND WARNING/INDICATOR
| *A | for Analog Meter | *B | for Optitron Meter |
| *1 | Speedometer | *2 | Tachometer |
| *3 | Engine Coolant Temperature Receiver Gauge | *4 | Fuel Receiver Gauge |
| *5 | Multi-information Display | - | - |
| Item | Details |
|---|---|
| Speedometer | Based on a signal received from the wheel speed sensors, the skid control ECU calculates the vehicle speed and transmits data to the combination meter (CAN). |
| Tachometer | The combination meter receives an engine speed signal from the ECM and the gauge needle operates (Direct line and/or CAN). |
| Engine Coolant Temperature Receiver Gauge | The combination meter receives an engine coolant temperature signal from the ECM and the gauge needle operates (Direct line and/or CAN). |
| Fuel receiver gauge | The combination meter receives fuel amount information measured by the fuel sender gauge and the gauge needle operates (Direct line). |
| Item | Details |
|---|---|
BEAM indicator light
|
Receives BEAM indicator light signals from the main body ECU (CAN). |
DOOR warning light
|
The open door indicator comes on when a signal is received from the main body ECU (CAN). |
FRONT FOG indicator light*1
|
The indicator turns on when a FRONT FOG illumination command signal is received (CAN). |
REAR FOG indicator light*2
|
The indicator turns on when a REAR FOG illumination command signal is received (CAN). |
SRS warning light
|
Receives malfunction signals from the center airbag sensor (CAN). |
Front seat belt warning light
|
·
Receives driver seat belt signals (unfastened) from the main body ECU (CAN). ·
Receives front passenger seat belt signals (unfastened) from the front seat inner belt RH*36, LH*37 (Direct line). |
Brake warning light
|
·
Comes on when the parking brake switch is on (CAN). ·
Comes on when the brake fluid level warning switch is on (Direct line or CAN). |
ABS warning light
|
Receives malfunction signals from the skid control ECU (CAN). |
CHARGE warning light
|
·
Receives malfunction signals from the generator (Direct line).*29 ·
Receives malfunction signals from the ECM (CAN).*30 |
MIL
|
·
Receives malfunction signals from the ECM (CAN).*31 ·
Receives malfunction signals from the ECM (Direct line).*32 |
FUEL warning light
|
Receives signals from the fuel sender gauge indicating low or no fuel (Direct line). |
SLIP indicator light*3
|
Receives malfunction signals from the skid control ECU (CAN). |
VSC OFF indicator light*3
|
Receives VSC OFF signals from the skid control ECU (CAN). |
TRC OFF indicator light*3
|
Receives TRC OFF signals from the skid control ECU (CAN). |
TAIL indicator light
|
The indicator turns on when a taillight illumination signal is received (CAN). |
Turn signal indicator light (LH/RH)
|
Receives a turn signal from the flasher relay (Direct line). |
PPS warning light*3, *33
|
Receives power steering warning signals from the power steering ECU (CAN). |
Master warning light*5
|
Receives warning signals from sensors and ECUs (Direct line and CAN). |
SIL indicator (UP/DOWN)*6, *7
|
Receives a shift signal from the ECM (CAN). |
Eco Driving Indicator Light*8
|
Receives an ecology light indicator signal from the ECM (CAN). |
Glow indicator*9
|
Receives a glow signal from the ECM (Direct line or CAN). |
Cruise indicator*10
|
Receives a cruise control switch signal from the ECM (CAN). |
Cruise set indicator*10
|
Receives a cruise control switch signal from the ECM (CAN). |
SPEED LIMIT indicator light*11
|
The indicator turns on when a vehicle speed signal is received (CAN). |
Downhill assist control indicator light*12
|
Receives Downhill assist control signals from the skid control ECU (CAN). |
CRAWL indicator light*13
|
Receives CRAWL signals from the skid control ECU (CAN). |
A/T OIL TEMP indicator light*4, *8
|
Receives automatic transmission signals from the ECM (CAN). |
T-BELT warning indicator light*4, *14
|
Illuminates when odometer's display is 150000 km or 90000 miles |
Oil Maintenance warning indicator light*4, *15
|
Receives oil maintenance signal from the ECM (CAN). |
Multi-terrain Select indicator light*13
|
Multi-terrain select signals from the driving support switch control ECU (CAN). |
Clearance Sonar indicator light*16, *17
|
Receives clearance sonar indicator light signals from the parking assist ECU (CAN). |
Center Differential Lock indicator light
|
Receives center differential lock signals from four wheel drive control ECU (CAN). |
Rear Differential Lock indicator light*18
|
Receives rear differential lock signals from four wheel drive control ECU (CAN). |
4LO indicator light
|
Receives 4LO indicator light signals from the four wheel drive control ECU (CAN). |
Oil pressure warning light
|
Receives an oil pressure warning light signal from the oil pressure switch. (Direct Line) |
SEDIMENT/FILTER warning light*19
|
Receives the sedimenter signal /fuel filter signal from the sedimenter switch/level warning switch (Direct Line). |
SEDIMENT warning light*20
|
Receives the sedimenter signal from the sedimenter switch (Direct Line). |
Key indicator light*4, *21
|
Receives a key signal from the certification ECU (CAN). |
OIL LEVEL warning light*4, *22, *23
|
Receives an oil level signal from the engine oil level sensor (Direct Line). |
2nd START indicator light*8
|
Receives a 2nd START switch ON signal from the ECM (CAN). |
PCS indicator light*24
|
Receives a PCS indicator light signal from the seat belt control ECU (CAN). |
Radar cruise indicator light*25
|
Receives radar cruise indicator signals from the driving support ECU (CAN). |
Kinetic dynamic suspension system indicator light*26
|
Receives kinetic dynamic suspension system signals from the kinetic dynamic suspension system control ECU (CAN). |
BSM indicator light*27
|
Receives BSM indicator light signals from the blind spot monitor sensor LH (CAN). |
Headlight beam level control system warning light*28
|
Receives headlight beam level control system warning light signals from the Headlight swivel ECU (CAN). |
LED headlight warning light*28
|
Receives LED headlight warning light signals from the main body ECU (CAN). |
Tire pressure warning light*34
|
Receives tire pressure warning light signals from the tire pressure monitor receiver (Direct Line). |
Washer level warning light*4, *35
|
Warning is displayed when the washer level is low (Direct Line). |
| Diesel particulate filter warning light*38 | Receives diesel particulate filter warning light signals from the ECM (CAN). |
| Reductant warning indicator*39 | Receives reductant warning indicator signals from the ECM (CAN). |
*1: w/ Front Fog Light
*2: w/ Rear Fog Light
*3: w/ VSC
*4: for Analog Meter, Segment Display Type
*5: except Analog Meter, Segment Display Type
*6: for Europe
*7: for Manual Transmission
*8: for Automatic Transmission
*9: for Diesel Engine
*10: w/ Cruise Control
*11: for Middle East
*12: w/ Downhill Assist Control
*13: w/ CRAWL Control
*14: for 1KD-FTV, 5L-E
*15: for 1KD-FTV, Europe
*16: w/ TOYOTA Parking Assist-sensor System
*17: for Optitron Meter
*18: w/ Rear Differential Lock
*19: w/ SEDIMENT/FILTER Warning Light
*20: w/ SEDIMENT Warning Light
*21: w/ Entry and Start System
*22: for 1KD-FTV, 1GD-FTV
*23: for 1GR-FE, Europe
*24: w/ Pre-crash Safety System
*25: w/ Dynamic Radar Cruise Control System
*26: w/ Kinetic Dynamic Suspension System
*27: w/ Blind Spot Monitor System
*28: for LED Headlight
*29: for 1KD-FTV, 1GR-FE, 5L-E
*30: for 1GD-FTV, 2TR-FE
*31: for 2TR-FE
*32: except 2TR-FE
*33: w/ Power Steering System
*34: w/ Tire Pressure Monitor System
*35: w/ Washer Fluid Level Warning System
*36: for LHD
*37: for RHD
*38: w/ DPF
*39: w/ Urea SCR System
MULTI-INFORMATION DISPLAY
for Analog Meter, Segment Display Type:
The information displayed changes in the following order each time the ODO/TRIP switch is pressed.
| *a | ODO | *b | TRIP A |
| *c | TRIP B | *d | Driving range |
| *e | Current fuel consumption | *f | ·
Average fuel consumption display ·
Eco driving indicator zone (for Automatic Transmission) |
| *g | Average vehicle speed | *h | Eco driving indicator light setting display (for Automatic Transmission) |
for Analog Meter, Dot Display Type:
The information displayed changes in the following order each time the ODO/TRIP switch is pressed.
| *a | ODO | *b | TRIP A |
| *c | TRIP B | *d | Driving range |
| *e | Current fuel consumption | *f | ·
Average fuel consumption display ·
Eco driving indicator zone (for Automatic Transmission) |
| *g | Average vehicle speed | *h | Settings |
for Optitron Meter:
The information displayed changes in the following order each time the ENTER switch is pressed.
| *a | Other (blank) | *b | Vehicle condition |
| *c | Digital speedometer | *d | Cruising range |
| *e | Average fuel consumption after refueling | *f | Current fuel consumption |
| *g | Average fuel consumption display | *h | Average vehicle speed |
| *i | Elapsed time | - | - |