Home › Vehicle Interior › METER / GAUGE / DISPLAY › TRIP SWITCH › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053733 METER / GAUGE / DISPLAY _0261083 TRIP SWITCH A

METER / GAUGE / DISPLAY  TRIP SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column)

a.

Disable the Autoaway/Return function by changing the customize parameter (See page Steering>STEERING COLUMN>POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM>CUSTOMIZE PARAMETERS).

NOTICE:

Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.


HINT:

Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.



b.

Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully extend and lower the steering column.


c.

Turn the ignition switch off.


Hide 55471A 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 55476C 3.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55480D 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55404D 5.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 84975 6.REMOVE TRIP SWITCH

a.
E194819

Detach the 2 claws and remove the trip switch.