Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053735 SUPPLEMENTAL RESTRAINT SYSTEMS _0261086 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using SST Check Wire)


a.

Check for DTCs (present trouble code).

i.

Turn the ignition switch to ON and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.




b.

Check for DTCs (past trouble code).

i.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.



ii.

Turn the ignition switch to ON and wait for approximately 60 seconds.



c.

Read the DTCs.

B450001E01
2.104,3.198 5.531,3.396 3.427,0.198 10 false Normal System Code (with Past Trouble Code): 3.083,1.823 4.031,2.01 0.948,0.188 10 false 0.25 sec. 1.875,1.313 2.313,1.51 0.438,0.198 10 false On 1.885,1.719 2.323,1.917 0.438,0.198 10 false Off 3,1.188 3.948,1.375 0.948,0.188 10 false 0.25 sec. 1.927,0.417 5.354,0.615 3.427,0.198 10 false Normal System Code (without Past Trouble Code): 1.969,4.354 2.406,4.552 0.438,0.198 10 false Off 1.948,3.958 2.385,4.156 0.438,0.198 10 false On 3.125,3.813 4.073,4 0.948,0.188 10 false 0.75 sec. 3.313,4.427 4.26,4.615 0.948,0.188 10 false 0.25 sec. 2.031,5.833 5.458,6.031 3.427,0.198 10 false Normal System Code (with Past Trouble Code): 3.375,7.458 3.958,7.635 0.583,0.177 10 false DTC 31 2.573,7.448 3.167,7.625 0.594,0.177 10 false DTC 11 2.115,6.417 2.635,6.615 0.521,0.198 10 false 0.5 sec. 2.146,6.979 2.719,7.167 0.573,0.188 10 false 1.5 sec. 4.354,7.24 5.302,7.427 0.948,0.188 10 false Repeat 3.74,6.219 4.688,6.406 0.948,0.188 10 false 4.0 sec. 2.938,6.219 3.5,6.427 0.563,0.208 10 false 2.5 sec. 3.49,7 4.01,7.198 0.521,0.198 10 false 0.5 sec.

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.

·

Normal system code indication (without past trouble code):

The light blinks twice per second.

·

Normal system code indication (with past trouble code):

When a past trouble code is stored in the center airbag sensor, the light blinks only once per second.

·

Trouble code indication:

Each digit of a DTC is separated by a 1.5 second pause.


If there is more than 1 code, there is a 2.5 second pause between each code. After all the codes are output, there is a 4.0 second pause, and then all codes are repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller-numbered code.

·

If DTCs are output without connecting the terminals, proceed to "Diagnosis Circuit" (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>Diagnosis Circuit).






CLEAR DTC (Using SST Check Wire)


a.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next step.



b.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch to ON.

SST
09843-18040  


c.

Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output and check that the SRS warning light comes on after 3 seconds.


d.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.


e.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13 (TC) within 2 to 4 seconds after the SRS warning light goes off.


f.

Check that the SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.


g.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also check that the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

C123780E32
0.444,0.382 1.405,0.571 0.961,0.189 10 Ignition Switch 0.302,1.153 1.545,1.345 1.243,0.192 10 DLC3 (TC and CG) 0.255,2.116 1.591,2.323 1.335,0.207 10 SRS Warning Light* 3.072,1.68 3.597,1.889 0.525,0.209 10 0.5 sec. 5.546,1.698 6.625,2.049 1.079,0.35 5.57,1.68 6.151,1.887 0.581,0.207 10 0.25 sec. 0.194,2.565 1.159,2.742 0.965,0.177 10 T1: 0 to ∞ sec. 0.194,2.886 1.354,3.090 1.160,0.204 10 T2: approx. 6 sec. 0.194,3.207 1.133,3.406 0.939,0.199 10 T3: 3 to 5 sec. 0.194,3.528 1.179,3.736 0.985,0.207 10 T4: 3 to 10 sec. 0.194,3.849 1.127,4.029 0.933,0.179 10 T5: 2 to 4 sec. 0.194,4.17 1.123,4.348 0.929,0.177 10 T6: 1 to 5 sec. 0.194,4.492 1.249,4.680 1.055,0.189 10 T7: within 1 sec. 2.31,4.1 6.821,4.338 4.510,0.237 10 *: The past trouble code in the illustration shows DTC 21 as an example. 2.46,3.455 2.658,3.680 0.198,0.225 10 T1 5.953,3.455 6.179,3.680 0.226,0.225 10 T7 4.417,3.455 4.615,3.680 0.198,0.225 10 T6 4.164,3.455 4.347,3.680 0.183,0.225 10 T5 3.727,3.455 3.949,3.680 0.222,0.225 10 T4 3.24,3.455 3.454,3.680 0.214,0.225 10 T3 2.84,3.455 3.078,3.680 0.238,0.225 10 T2 4.935,3.455 5.118,3.680 0.183,0.225 10 T6 4.683,3.455 4.873,3.680 0.190,0.225 10 T5 5.446,3.455 5.637,3.680 0.190,0.225 10 T6 5.194,3.455 5.385,3.680 0.190,0.225 10 T5 5.708,3.455 5.936,3.680 0.228,0.225 10 T5 6.196,1.68 6.795,1.887 0.599,0.207 10 0.25 sec. 3.632,1.68 4.145,1.889 0.513,0.209 10 0.5 sec. 1.737,0.395 2.373,0.598 0.636,0.203 10 ON 1.737,0.827 2.179,1.024 0.442,0.198 10 Off 1.737,1.555 2.138,1.747 0.401,0.192 10 Short 1.737,1.153 2.154,1.335 0.417,0.182 10 Open 1.737,2.134 1.993,2.301 0.256,0.166 10 On 1.737,2.498 2.065,2.675 0.328,0.177 10 Off 3.593,2.806 4.118,3.014 0.525,0.209 10 1.5 sec.



CHECK DTC (Using the Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / SRS Airbag / Trouble Codes.



CLEAR DTC (Using the Intelligent Tester)


a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / SRS Airbag / Trouble Codes.


e.

Clear the DTCs.