Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work. (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
2.REMOVE LOWER NO. 3 STEERING WHEEL COVER
Detach the 2 claws and remove the cover.
45186
3.REMOVE LOWER NO. 2 STEERING WHEEL COVER
Detach the 2 claws and remove the cover.
| *A | w/o Cruise Control System |
| *B | w/ Cruise Control System |
45130
4.REMOVE STEERING PAD
Using a T30 "TORX" socket wrench, loosen the 2 screws until the groove along the screw circumference catches on the screw case.
| *1 | Screw Case |
Pull out the steering pad from the steering wheel as shown in the illustration. Then support the steering pad with one hand.
When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors and remove the steering pad.
When handling the airbag connector, take care not to damage the airbag wire harness.