This DTC is stored during the seat belt control ECU self-diagnosis or when power is not supplied to the seat belt control ECU.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2036 | An open in the power supply circuit. | ·
Harness or connector ·
Seat belt control ECU |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the G118 ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G118-7 (+B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G118-8 (PGND) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Seat Belt Control ECU) |
OK
NG