Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053736 PRE-CRASH SAFETY _0261101 PRE-CRASH SAFETY SYSTEM D

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  DIAGNOSIS SYSTEM  


INITIAL CHECK


a.

2 seconds or more after turning the ignition switch off, turning the ignition switch to ON causes the pre-crash safety system to perform an initial check for approximately 3 seconds.


b.

If a malfunction is detected in the initial check, after the 3 second initial check, the multi-information display in the combination meter assembly displays "CHECK PCS SYSTEM".

HINT:

"CHECK PCS SYSTEM" is displayed when a pre-crash safety system malfunction has been detected and a DTC is stored.




CONSTANT CHECK


a.

After the 3 second initial check, the seat belt control ECU and driving support ECU control the system and perform a constant check to monitor the system.


b.

If a malfunction is detected in the constant check, the multi-information display in the combination meter assembly displays "CHECK PCS SYSTEM" or "PCS TEMPORARILY NOT AVAILABLE".

HINT:

"PCS TEMPORARILY NOT AVAILABLE" is displayed during the following conditions: 1) the seat belt control ECU overheating prevention function has operated; 2) due to bad weather, the radar cannot detect obstacles; or 3) foreign matter is attached to the grille cover or millimeter wave radar sensor assembly.


E177609E01
1.358,0.696 2.831,0.855 1.473,0.158 10 Turn ignition switch ON 4.308,0.433 5.985,0.790 1.677,0.357 10 (Approximately 3 seconds) Initial Check 4.595,1.876 5.640,2.032 1.045,0.156 10 Constant Check 1.398,1.905 2.843,2.063 1.445,0.158 10 Turn ignition switch off