Home › Vehicle Interior › SEAT › REAR POWER SEAT CONTROL SYSTEM
RM27T0E _58 Vehicle Interior _053737 SEAT _0261112 REAR POWER SEAT CONTROL SYSTEM D

SEAT  REAR POWER SEAT CONTROL SYSTEM  INITIALIZATION  


INITIAL POSITION MEMORIZATION


NOTICE:

When the following actions are performed, initial position memorization is necessary:

·

The fold seat control ECU is replaced with a new one.

·

The fold seat control ECU initial position memory is reset.



HINT:

When the ignition switch is turned to ON before performing initial position memorization, a buzzer sounds continuously while the ignition switch is ON. Once initial position memorization is complete, the buzzer stops.


a.

Initial Position Memorization

i.

Hold the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly in the return position until the seat cushion is completely restored to its seating position and the seatback is fully reclined.


ii.

Hold the No. 1 fold seat switch assembly or No. 2 fold seat switch assembly in the stowage position until the seatback and seat cushion are completely stowed.




INITIAL POSITION MEMORY RESET


NOTICE:

When the following actions are performed, initial position memory reset is necessary:

·

The battery is disconnected while the seatback or seat cushion is moving.

·

The fold seat control ECU is replaced with another used fold seat control ECU.

·

The seatback or seat cushion is moved while the fold seat control ECU is disconnected.

·

The relationship of the positions of the seatback and seat cushion becomes abnormal due to removal/installation, replacement, etc. of the seat.



a.

Initial Position Memory Reset

i.

Press and hold the No. 1 fold seat switch assembly in the return position.


ii.

Within 10 seconds of pressing the No. 1 fold seat switch assembly, press the rear power seat switch 5 times in the direction which moves the seatback forwards.

HINT:
·

Make sure to hold the return switch of the No. 1 fold seat switch assembly until the reinitialization process complete buzzer sounds.

·

When the initial position memory reset is completed, a buzzer will sound 3 times.

·

When the ignition switch is turned to ON after initial position memory reset is completed, a buzzer sounds continuously while the ignition switch is ON.