Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Power Seat) › 2015.06–2020.08
RM27T0E _58 Vehicle Interior _053737 SEAT _0261115 FRONT SEAT ASSEMBLY(for Power Seat) A

SEAT  FRONT SEAT ASSEMBLY(for Power Seat)  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

Wear protective gloves. Sharp areas on the parts may injure your hands.

·

If the side airbag was deployed, replace the front seat side airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage.



HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.

·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 71910A 2.REMOVE FRONT SEAT HEADREST ASSEMBLY

a.

Remove the front seat headrest assembly.


Hide 72128A 3.REMOVE FRONT SEAT INNER TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the seat to the rearmost position.


b.
B241794

Using a moulding remover, detach the 2 claws.


c.

Move the front seat inner track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the front seat inner track bracket cover LH.


Hide 72124 4.REMOVE FRONT SEAT OUTER TRACK BRACKET COVER LH

a.
B239528

Using a moulding remover, detach the 2 claws.


b.

Move the front seat outer track bracket cover LH in the direction of the arrow to detach the 2 claws and guide and remove the front seat outer track bracket cover LH.


Hide 72158 5.REMOVE INNER SEAT TRACK BRACKET COVER LH

a.

Operate the power seat switch (slide switch) to move the seat to the foremost position.


b.
B238099

Using a moulding remover, detach the 2 claws.


c.

Move the inner seat track bracket cover LH in the direction of the arrow to detach the 2 guides and remove the inner seat track bracket cover LH.


Hide 72138B 6.REMOVE SEAT TRACK COVER LH

a.
B238101

Using a moulding remover, detach the 2 claws.


b.

Move the seat track cover LH in the direction of the arrow to detach the 4 guides and remove the seat track cover LH.


Hide 7.REMOVE FRONT SEAT ASSEMBLY

a.
B238103

Remove the 2 bolts.


b.

Operate the power seat switch (slide switch) to move the seat to the rearmost position.


c.
B239529

Remove the 2 bolts.


d.

Operate the power seat switch (slide switch) to move the seat to the center position, and operate the power seat switch (reclining switch) to move the seatback to the upright position.


e.

Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the battery negative (-) terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



f.

Disconnect the connectors under the seat.


g.

Remove the front seat assembly.

NOTICE:

Be careful not to damage the vehicle body.