84751G
1.INSPECT SEAT HEATER SWITCH LH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 3 (SW) - 7 (RV) | Switch off | 2.7 to 4.1 kΩ |
| Switch on (Min.) | ||
| Switch on (Max.) | 0.28 to 0.42 kΩ |
As the dial is being turned, the resistance changes gradually.
If the result is not as specified, replace the seat heater switch.
| *a | Component without harness connected
(Seat Heater Switch) |
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 8 (ILL+)
Battery negative (-) → 2 (ILL-) |
Illuminates |
If the result is not as specified, replace the seat heater switch.
Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+) → 9 (IG)
Battery negative (-) → 4 (E) |
Switch on | Indicator illuminates |
If the result is not as specified, replace the seat heater switch.
84751G
2.INSPECT SEAT HEATER SWITCH RH
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 2 (SW) - 5 (RV) | Switch off | 2.7 to 4.1 kΩ |
| Switch on (Min.) | ||
| Switch on (Max.) | 0.28 to 0.42 kΩ |
As the dial is being turned, the resistance changes gradually.
If the result is not as specified, replace the seat heater switch.
| *a | Component without harness connected
(Seat Heater Switch) |
Apply battery voltage to the switch connector, and check that the seat heater switch illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 6 (ILL+)
Battery negative (-) → 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the seat heater switch.
Apply battery voltage to the switch connector, and check that the seat heater switch indicator illuminates.
| Measurement Condition | Switch Condition | Specified Condition |
|---|---|---|
| Battery positive (+) → 7 (IG)
Battery negative (-) → 3 (E) |
Switch on | Indicator illuminates |
If the result is not as specified, replace the seat heater switch.