Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87510N
1.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH
Set the seatback heater with the name stamp side facing the seatback cover.
| *1 | Tack Pin |
| *2 | Seatback Cover |
| *3 | Seatback Heater |
| *4 | Name Stamp |
Install the seatback heater with new tack pins.
71074S
2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
Using hog ring pliers, install the seatback cover to the seatback pad with new hog rings.
| *1 | Hog Ring Pliers |
Be careful not to damage the cover.
When installing the hog rings, avoid wrinkling the cover.
Attach the 4 claws to install the 2 headrest supports.
w/ Front Seat Side Airbag:
Connect the seatback cover bracket to the seatback pad.
Install the seatback cover bracket to the seat frame with the nut.
After the seatback trim cover is assembled, make sure the side airbag strap is not twisted.
w/o Seatback board:
Close the 2 fasteners, and then close the seatback cover.
| *A | for Cloth Seat | *B | for Leather Seat |
Using hog ring pliers, install 3 new hog rings.
| *1 | Hog Ring Pliers |
Connect the seat heater connector and attach the wire harness clamp.
Install the rubber band to the seat cushion spring.
w/ Seatback Board:
Using hog ring pliers, install 5 new hog rings.
| *1 | Hog Ring Pliers |
Be careful not to damage the separate type front seatback cover.
Be sure to securely install the hog rings as shown in the illustration while preventing wrinkles from forming on the separate type front seatback cover.
Attach the hooks.
Connect the seat heater connector and attach the wire harness clamp.
71706B
3.INSTALL FRONT SEATBACK BOARD CLIP (w/ Seatback Board)
71706
4.INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH (w/ Seatback Board)
5.INSTALL FRONT SEAT ASSEMBLY
Install the front seat assembly (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Power Seat)>INSTALLATION).