Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
73390C
1.INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY LH
Install the inner belt and connect the 3 point type belt anchor with the bolt.
Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding part of the front seat adjuster.
| *a | Protruding Part |
2.INSTALL SEAT CUSHION COVER WITH PAD
72616A
3.INSTALL REAR SEATBACK LOCK STRIKER COVER LH
71826B
4.INSTALL REAR SEAT CUSHION MOULDING LH
71396B
5.INSTALL CENTER SEAT HINGE COVER LH
72526A
6.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
71846A
7.INSTALL REAR SEAT UPPER RECLINING COVER LH
8.INSTALL REAR SEAT ASSEMBLY LH
Install the rear seat assembly LH (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)>INSTALLATION).