Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT OUTER BELT ASSEMBLY (for 60/40 Split Slide Walk-in Seat Type LH Side)
RM27T0E _58 Vehicle Interior _053738 SEAT BELT _0261163 REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side) G

SEAT BELT  REAR CENTER SEAT OUTER BELT ASSEMBLY(for 60/40 Split Slide Walk-in Seat Type LH Side)  INSPECTION  


PROCEDURE

Hide 73320A 1.INSPECT NO. 1 SEAT 3 POINT TYPE BELT ASSEMBLY LH

B242818E01
1.209,0 1.404,0.211 0.195,0.211 10 *c 2.415,0 2.640,0.202 0.225,0.202 10 *a 0.473,0.527 0.684,0.784 0.211,0.258 10 *b

NOTICE:

Do not disassemble the retractor.


Text in Illustration
*a Unlock
*b Lock
*c 45°

a.

When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

If the operation is not as specified, replace the No. 1 seat 3 point type belt assembly LH.


b.

Check the fastening function of the child restraint system.

NOTICE:

The check should be performed with the outer belt installed.


i.

When the belt is pulled out fully, the belt should automatically start to retract.


ii.

After the belt has fully retracted, the belt should be able to be pulled out and retracted again. If the operation is not as specified, replace the No. 1 seat 3 point type belt assembly LH.