Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System)
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261169 AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Automatic Air Conditioning System)  Generator Signal Circuit  


DESCRIPTION

When the engine is started, the generator assembly turns on and a voltage pulse signal is generated.

This signal is used by the air conditioning amplifier assembly.

The signal expressing the amount of output from the generator assembly is one element of PTC heater control.

WIRING DIAGRAM

E145301E29
4.865,3.103 7.151,3.492 2.286,0.389 10 Air Conditioning Amplifier Assembly 0.85,3.07 2.152,3.282 1.302,0.211 10 Generator Assembly 0.859,2.941 1.683,3.106 0.824,0.165 10 D3*1, C65*2 4.855,2.922 5.168,3.069 0.313,0.147 10 G25 1.532,1.41 1.686,1.587 0.154,0.177 10 M 5.763,1.396 6.046,1.589 0.284,0.193 10 ALT 5.408,1.263 5.629,1.430 0.221,0.167 10 25 1.861,1.289 1.976,1.458 0.115,0.169 10 3 0.133,3.546 1.219,3.702 1.086,0.156 10 *2: for 1KD-FTV 0.133,3.32 1.112,3.476 0.979,0.156 10 *1: for 1GR-FE

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - GENERATOR)
a.

Disconnect the G25 amplifier connector.


b.

Disconnect the D3*1 or C65*2 generator connector.

*1: for 1GR-FE

*2: for 1KD-FTV



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for 1GR-FE
Tester Connection Condition Specified Condition
G25-25 (ALT) - D3-3 (M) Always Below 1 Ω
G25-25 (ALT) - Body ground Always 10 kΩ or higher

for 1KD-FTV
Tester Connection Condition Specified Condition
G25-25 (ALT) - C65-3 (M) Always Below 1 Ω
G25-25 (ALT) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR