This circuit consists of the air conditioning control assembly and air conditioning amplifier. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control assembly is operated.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Check the vehicle type.
| Result | Proceed to |
|---|---|
| w/o Rear Seat Heater | A |
| w/ Rear Seat Heater | B |
A
B
Disconnect the G24 amplifier connector.
Disconnect the T3 control connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T3-3 (RLIN) - G24-13 (RLIN) | Always | Below 1 Ω |
| T3-3 (RLIN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the T3 control connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| T3-5 (IG) - T3-8 (E) | Ignition switch off | Below 1 V |
| T3-5 (IG) - T3-8 (E) | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T3-8 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Air Conditioning Control Assembly) |
OK
NG
Replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING PANEL>REMOVAL).
Operate the air conditioning control assembly to check that it functions properly.
Air conditioning control assembly operates normally.
OK
NG
Disconnect the G24 amplifier connector.
Disconnect the T7 control connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T7-6 (RLIN) - G24-13 (RLIN) | Always | Below 1 Ω |
| T7-6 (RLIN) - Body ground | Always | 10 kΩ or higher |
OK
NG
Disconnect the T7 control connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| T7-1 (IG) - T7-8 (E) | Ignition switch off | Below 1 V |
| T7-1 (IG) - T7-8 (E) | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| T7-8 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Air Conditioning Control Assembly) |
OK
NG
Replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING PANEL>REMOVAL).
Operate the air conditioning control assembly to check that it functions properly.
Air conditioning control assembly operates normally.
OK
NG