Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM (for Manual Air Conditioning System)
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261170 AIR CONDITIONING SYSTEM(for Manual Air Conditioning System) J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM(for Manual Air Conditioning System)  Rear Air Conditioning Control Panel Circuit  


DESCRIPTION

This circuit consists of the air conditioning control assembly and air conditioning amplifier. When the air conditioning control assembly is operated, signals are transmitted to the air conditioning amplifier through the LIN communication system.

If the LIN communication system malfunctions, the air conditioning amplifier does not operate even if the air conditioning control assembly is operated.

WIRING DIAGRAM

E324179E01
5.564,0.845 5.967,1.026 0.403,0.181 10 RLIN 1.389,0.845 1.741,1.026 0.353,0.181 10 RLIN 0.079,0.011 2.369,0.271 2.291,0.260 12 w/o Rear Seat Heater: 1.542,1.368 1.787,1.549 0.245,0.181 10 IG 1.566,1.911 1.759,2.092 0.194,0.181 10 E 3.724,1.376 5.140,1.550 1.416,0.174 10 from IG1 NO.1 Relay 2.455,1.515 3.370,1.696 0.916,0.181 10 ECU-IG NO.2 5.525,2.648 6.991,3.054 1.467,0.406 10 Air Conditioning Amplifier Assembly 5.525,2.47 5.853,2.639 0.328,0.169 10 G24 0.671,2.62 2.206,2.953 1.535,0.333 10 Air Conditioning Control Assembly 0.886,3.296 2.501,3.477 1.615,0.181 10 : LIN Communication Line 5.255,0.676 5.426,0.857 0.171,0.181 10 13 1.833,1.256 1.989,1.437 0.156,0.181 10 5 1.833,1.811 1.989,1.992 0.156,0.181 10 8 1.83,0.653 2.016,0.835 0.186,0.181 10 3 0.671,2.446 0.961,2.630 0.290,0.184 10 T3

E324179E02
5.564,0.845 5.967,1.026 0.403,0.181 10 RLIN 1.389,0.845 1.741,1.026 0.353,0.181 10 RLIN 0.079,0.011 2.369,0.271 2.291,0.260 12 w/ Rear Seat Heater: 1.542,1.368 1.787,1.549 0.245,0.181 10 IG 1.566,1.911 1.759,2.092 0.194,0.181 10 E 3.724,1.376 5.140,1.550 1.416,0.174 10 from IG1 NO.1 Relay 2.455,1.515 3.370,1.696 0.916,0.181 10 ECU-IG NO.2 5.525,2.648 6.991,3.054 1.467,0.406 10 Air Conditioning Amplifier Assembly 5.525,2.47 5.853,2.639 0.328,0.169 10 G24 0.671,2.619 2.206,2.953 1.535,0.333 10 Air Conditioning Control Assembly 0.886,3.296 2.501,3.477 1.615,0.181 10 : LIN Communication Line 5.255,0.676 5.426,0.857 0.171,0.181 10 13 1.833,1.256 1.989,1.437 0.156,0.181 10 1 1.833,1.811 1.989,1.992 0.156,0.181 10 8 1.83,0.653 2.016,0.835 0.186,0.181 10 6 0.671,2.446 0.961,2.630 0.290,0.184 10 T7

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK VEHICLE TYPE
a.

Check the vehicle type.


Result
Result Proceed to
w/o Rear Seat Heater A
w/ Rear Seat Heater B


A

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)

B

5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)
2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)
a.

Disconnect the G24 amplifier connector.


b.

Disconnect the T3 control connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T3-3 (RLIN) - G24-13 (RLIN) Always Below 1 Ω
T3-3 (RLIN) - Body ground Always 10 kΩ or higher




OK

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)
a.
U149300E01
0.119,0 0.385,0.191 0.266,0.191 10 *a 2.055,1.254 2.613,1.591 false 0.615,1.597 0.881,1.788 0.266,0.191 10 IG 1.377,1.302 0.787,1.599 false 2.658,1.551 2.831,1.742 0.173,0.191 10 E 0.474,0.954 0.689,1.144 0.215,0.191 10 T3

Disconnect the T3 control connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
T3-5 (IG) - T3-8 (E) Ignition switch off Below 1 V
T3-5 (IG) - T3-8 (E) Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T3-8 (E) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Air Conditioning Control Assembly)


OK

4.CHECK AIR CONDITIONING CONTROL ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK AIR CONDITIONING CONTROL ASSEMBLY
a.

Replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING PANEL>REMOVAL).


b.

Operate the air conditioning control assembly to check that it functions properly.

OK:

Air conditioning control assembly operates normally.




OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS FAULTY)

NG

5.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - AIR CONDITIONING AMPLIFIER)
a.

Disconnect the G24 amplifier connector.


b.

Disconnect the T7 control connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T7-6 (RLIN) - G24-13 (RLIN) Always Below 1 Ω
T7-6 (RLIN) - Body ground Always 10 kΩ or higher




OK

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

6.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL - BATTERY AND BODY GROUND)
a.
U170254E01
0.415,1.095 0.701,1.241 0.286,0.147 10 T7 2.366,1.048 2.618,0.611 2.618,0.611 2.756,0.611 false 2.8,0.525 3.134,0.692 0.334,0.166 10 E 1.135,1.032 0.877,0.746 0.877,0.746 0.738,0.746 false 0.476,0.653 0.675,0.819 0.198,0.166 10 IG 0.082,0 0.281,0.166 0.198,0.166 10 *a

Disconnect the T7 control connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
T7-1 (IG) - T7-8 (E) Ignition switch off Below 1 V
T7-1 (IG) - T7-8 (E) Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T7-8 (E) - Body ground Always Below 1 Ω



Text in Illustration
*a Front view of wire harness connector
(to Air Conditioning Control Assembly)


OK

7.CHECK AIR CONDITIONING CONTROL ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.CHECK AIR CONDITIONING CONTROL ASSEMBLY
a.

Replace the air conditioning control assembly with a new or normally functioning one (See page Vehicle Interior>HEATING / AIR CONDITIONING>REAR AIR CONDITIONING PANEL>REMOVAL).


b.

Operate the air conditioning control assembly to check that it functions properly.

OK:

Air conditioning control assembly operates normally.




OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS FAULTY)

NG