88688K
1.REMOVE COOLER COMPRESSOR BRACKET
Detach the clamp.
| *A | except Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV |
| *B | Model Code KDJ150L-GKFEYV, KDJ150L-GKAEYV |
| *C | for Cold Area Specification Vehicles |
Remove the screw and cooler bracket.
2.REMOVE MAGNETIC CLUTCH ASSEMBLY
Place the cooler compressor in a vise.
Using SST, hold the magnet clutch hub.
| *A | except Cold Area Specification Vehicles |
| *B | for Cold Area Specification Vehicles |
Remove the bolt, magnet clutch hub and magnet clutch washers.
There is no set number of magnet clutch washer since they are used for adjusting.
Using a snap ring expander, remove the snap ring and magnet clutch rotor.
Take care not to damage the seal cover of the bearing when removing the snap ring.
Disconnect the connector.
Using a snap ring expander, remove the snap ring and magnet clutch stator.