Home › Vehicle Interior › HEATING / AIR CONDITIONING › ROOM TEMPERATURE SENSOR (for Front Side) › 2015.06–2017.08
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261196 ROOM TEMPERATURE SENSOR(for Front Side) A

HEATING / AIR CONDITIONING  ROOM TEMPERATURE SENSOR(for Front Side)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 55471A 2.REMOVE INSTRUMENT CLUSTER FINISH PANEL ORNAMENT (for LHD)

Hide 55476C 3.REMOVE INSTRUMENT PANEL FINISH PLATE GARNISH (for RHD)

Hide 55480D 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55404D 5.REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Hide 83100 6.REMOVE COMBINATION METER ASSEMBLY

Hide 88625Q 7.REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR)

E198665

a.

Disconnect the connector and hose.


b.

Detach the 2 claws and remove the cooler thermistor.