Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR (for 1GD-FTV)
RM27T0E _58 Vehicle Interior _053739 HEATING / AIR CONDITIONING _0261204 COMPRESSOR(for 1GD-FTV) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 1GD-FTV)  REASSEMBLY  


PROCEDURE

Hide 88410 1.INSTALL MAGNET CLUTCH ASSEMBLY

E321881

a.

Install the magnet clutch stator with the parts shown in the illustration matched.


b.
I032461

Using a snap ring expander, install a new snap ring with the chamfered side facing up.

NOTICE:

When installing the snap ring, do not widen it excessively.



c.

Connect the connector.


d.
I031582

Using a snap ring expander, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

NOTICE:
·

Do not damage the seal cover of the bearing when installing the snap ring.

·

When installing the snap ring, do not widen it excessively.




e.

Install the compressor washer(s) and magnet clutch hub.

NOTICE:

Do not change the combination of the compressor washer(s) used before disassembly.



f.
E321882E07
0.479,0.427 1.073,0.427 false 0.198,0.354 0.646,0.604 0.448,0.25 10 false SST

Using SST, hold the magnet clutch hub and install the bolt.

SST
09985-00270  

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)

NOTICE:

Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.



Hide 2.INSTALL COOLER BRACKET

a.

Install the cooler bracket with the screw.


b.

Attach the clamp.


Hide 3.INSPECT MAGNET CLUTCH CLEARANCE

E324369E07
2.656,4.146 1.906,4.146 false 1.74,4.073 2.052,4.313 0.313,0.24 10 false *1 0.125,0.125 0.438,0.365 0.313,0.24 10 false *a

a.

Clamp the cooler compressor assembly in a vise.


b.

Set the dial indicator to the magnet clutch hub.


c.

Connect the battery positive lead to terminal 3 of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

Standard clearance:

0.30 to 0.55 mm (0.012 to 0.022 in.)


If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor washers to obtain the standard clearance.

NOTICE:

Adjustment should be performed with 3 or fewer magnet clutch washers.



d.

Remove the cooler compressor assembly from the vise.

Text in Illustration
*1 Battery
*a Component without harness connected
(Magnet Clutch Assembly)