This is power source circuit for the heater assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the heater assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A97-1 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A97-5 (B) - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to Heater Assembly) |
OK
NG