| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 010 | Battery voltage is 14 V or more for 20 seconds or more. | ·
Harness or connector ·
Battery ·
Heater assembly |
| 011 | Battery voltage is 10 V or less for 20 seconds or more. | ·
Harness or connector ·
Battery ·
Heater assembly |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the heater assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A97-5 (B) - Body ground | Always | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A97-1 (E) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Heater Assembly) |
OK
NG