Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
58910C
1.INSTALL REAR CONSOLE BOX ASSEMBLY
Connect each connector.
Install the rear console box with the 2 screws, clip and 5 bolts.
58903A
2.INSTALL REAR CONSOLE END PANEL SUB-ASSEMBLY
Connect each connector.
Attach the 4 clips and 4 claws to install the rear console end panel.
58861B
3.INSTALL NO. 1 CONSOLE BOX DUCT (for Single Air Conditioning System)
Install the No. 1 console box duct with the clip.
55084E
4.INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY (w/ Cool Box)
Attach the 4 claws to install the No. 1 heater to register duct.
Attach the 2 clamps.
5.INSTALL CONSOLE PANEL SUB-ASSEMBLY
Connect each connector.
Attach the 8 clips and 2 claws to install the console panel.
33504F
6.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY
Install the shift lever knob and twist it in the direction indicated by the arrow.
Install the shifting hole cover to the shift lever knob.
| *1 | Shifting Hole Cover |
58817A
7.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Attach the 2 clips and guide to install the front No. 2 console box insert.
55607
8.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.
Install the screw.
| *A | for LHD | *B | for RHD |
58816B
9.INSTALL FRONT NO. 1 CONSOLE BOX INSERT
Attach the 2 clips and guide to install the front No. 1 console box insert.
55606
10.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for LHD:
Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
for RHD:
Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
58831A
11.INSTALL FRONT CONSOLE UPPER PANEL GARNISH
w/o Seat Heater System:
Connect the connector.
Attach the 5 clips to install the front console upper panel garnish.
w/o CRAWL:
Connect each connector.
Attach the 5 clips to install the front console upper panel garnish.
w/ CRAWL:
Attach the 5 clips to install the front console upper panel garnish.
55449C
12.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Attach the 5 clips to install the No. 2 instrument panel finish panel cushion.
55436A
13.INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Attach the 4 clips to install the instrument panel finish panel end LH.
55448A
14.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
Use the same procedure described for the No. 2 instrument panel finish panel cushion.
55435A
15.INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Attach the 4 clips to install the instrument panel finish panel end RH.
84010A
16.INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY