Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
A bolt without a torque specification is shown in the standard bolt chart (See page General>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS).
58910C
1.INSTALL REAR CONSOLE BOX ASSEMBLY
Install the rear console box with the 2 screws and 2 bolts.
58821C
2.INSTALL UPPER CONSOLE PANEL
Connect the connector and attach the clamp.
Attach the 2 clips to install the upper console panel.
Install the 2 screws.
58817A
3.INSTALL FRONT NO. 2 CONSOLE BOX INSERT
Attach the 2 clips and guide to install the front No. 2 console box insert.
55607
4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Attach the 3 clips and 2 guides to install the No. 2 instrument panel under cover.
Install the screw.
| *A | for LHD | *B | for RHD |
58816B
5.INSTALL FRONT NO. 1 CONSOLE BOX INSERT
Attach the 2 clips and guide to install the front No. 1 console box insert.
55606
6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
for LHD:
Attach the 2 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
for RHD:
Attach the 3 clips and 2 guides to install the No. 1 instrument panel under cover.
Install the screw.
58831A
7.INSTALL FRONT CONSOLE UPPER PANEL GARNISH
Connect the connectors.
Attach the 5 clips to install the front console upper panel garnish.
55449C
8.INSTALL NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
Attach the 5 clips to install the No. 2 instrument panel finish panel cushion.
55436A
9.INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Attach the 4 clips to install the instrument panel finish panel end.
55448A
10.INSTALL NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
Use the same procedure described for the No. 2 instrument panel finish panel cushion.
55435A
11.INSTALL INSTRUMENT PANEL FINISH PANEL END RH
Connect the connector.
Attach the 4 clips to install the instrument panel finish panel end.
84010A
12.INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY