Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
84040
1.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for 5 Door)
Check that the LED illuminates.
Apply battery voltage to the master switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 18 (LED)
Battery negative (-) → 12 (GND) |
LED illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |
84040
2.INSPECT MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for 3 Door)
Check that the LED illuminates.
Apply battery voltage to the master switch and check that the LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → 18 (LED)
Battery negative (-) → 12 (GND) |
LED illuminates |
If the result is not as specified, replace the multiplex network master switch assembly.
| *a | Component without harness connected
(Multiplex Network Master Switch Assembly) |