Home › Vehicle Exterior › WINDOW / GLASS › REAR POWER WINDOW SWITCH
RM27T0E _59 Vehicle Exterior _053742 WINDOW / GLASS _0261231 REAR POWER WINDOW SWITCH G

WINDOW / GLASS  REAR POWER WINDOW SWITCH  INSPECTION  


PROCEDURE

Hide 84810D 1.INSPECT REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY

U147959E01
0.177,1.526 0.379,1.742 0.203,0.215 10 *a 2.175,0.084 2.378,0.299 0.203,0.215 10 *1 0.399,2.57 0.838,2.739 0.439,0.169 10 AUTO 0.338,3.048 0.828,3.217 0.490,0.169 10 DOWN 2.557,2.22 2.908,2.388 0.351,0.169 10 GND 2.514,3.113 2.740,3.282 0.226,0.169 10 UP 0.5,2.215 0.809,2.371 0.309,0.156 10 LED 2.002,2.59 2.42,2.304 2.42,2.304 2.529,2.304 false 1.852,2.919 2.395,3.211 2.395,3.211 2.477,3.211 false 1.36,2.643 0.999,2.304 0.999,2.304 0.873,2.304 false 1.337,2.903 0.999,2.659 0.999,2.659 0.896,2.659 false 1.547,2.939 1.016,3.14 1.016,3.14 0.902,3.14 false 1.671,0.525 2.079,0.194 2.079,0.194 2.182,0.194 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (UP) - 1 (GND) Manual up operation Below 1 Ω
7 (DOWN) - 1 (GND) Manual down operation Below 1 Ω
8 (AUTO) - 1 (GND) Auto up/down operation Below 1 Ω


If the result is not as specified, replace the rear power window regulator switch assembly.



b.

Check that the LED illuminates.

i.

Apply battery voltage to the regulator switch and check that the LED illuminates.

OK:
Measurement Condition Specified Condition
Battery positive (+) → 4 (LED)
Battery negative (-) → 1 (GND)
LED illuminates


If the result is not as specified, replace the rear power window regulator switch assembly.


Text in Illustration
*1 LED
*a Component without harness connected
(Rear Power Window Regulator Switch Assembly)