Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM › 2015.06–2016.08
RM27T0E _59 Vehicle Exterior _053743 SLIDING ROOF / CONVERTIBLE _0261242 SLIDING ROOF SYSTEM J

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SYSTEM  Sliding Roof ECU Power Source Circuit  


DESCRIPTION

If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof drive gear sub-assembly power source circuit.

WIRING DIAGRAM

B243268E01
0.734,0.448 1.632,0.646 0.898,0.198 10 from Battery 2.076,0.62 2.781,0.801 0.705,0.182 10 S/ROOF 4.02,1.136 4.840,1.512 0.820,0.376 10 Sliding Roof ECU 5.097,0.852 6.324,1.061 1.227,0.209 10 Sliding Roof Motor 3.368,3.302 5.873,3.483 2.505,0.181 10 Sliding Roof Drive Gear Sub-assembly 5.369,1.419 5.857,1.628 0.488,0.209 10 Hall IC 5.369,2.177 5.857,2.386 0.488,0.209 10 Hall IC 3.219,0.383 3.339,0.532 0.120,0.149 10 1 3.428,0.384 3.681,0.554 0.254,0.170 10 B 3.371,3.15 3.625,3.320 0.254,0.170 10 W2 3.209,2.033 3.328,2.183 0.120,0.149 10 2 3.426,2.037 3.679,2.207 0.254,0.170 10 E

CAUTION / NOTICE / HINT

NOTICE:
·

When the sliding roof drive gear sub-assembly is removed and reinstalled or replaced, the sliding roof drive gear sub-assembly must be initialized (See page Vehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - BATTERY AND BODY GROUND)
U115630E03
1.188,0.729 1.448,1.115 false 1.521,0.615 1.646,1.115 false 0.115,0.031 0.344,0.219 0.229,0.188 10 false *a 0.521,1.146 0.792,1.333 0.271,0.188 10 false W2 1.063,0.563 1.271,0.76 0.208,0.198 10 false B 1.438,0.417 1.646,0.667 0.208,0.25 10 false E

a.

Disconnect the W2 ECU connector.


b.

Measure the resistance and voltage according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
W2-2 (E) - Body ground Always Below 1 Ω

Standard Voltage:
Tester Connection Condition Specified Condition
W2-1 (B) - Body ground Always 11 to 14 V



Text in Illustration
*a Front view of wire harness connector
(to Sliding Roof Drive Gear Sub-assembly)


OK

REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR