Home › Vehicle Exterior › DOOR / HATCH › HOOD SUPPORT
RM27T0E _59 Vehicle Exterior _053744 DOOR / HATCH _0261245 HOOD SUPPORT A

DOOR / HATCH  HOOD SUPPORT  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 53482 1.INSTALL HOOD SUPPORT BRACKET LH

a.
B238469

Install the hood support bracket with the 2 bolts.

Torque:
18 N*m (184 kgf*cm, 13 in.*lbf)


Hide 53450A 2.INSTALL HOOD SUPPORT ASSEMBLY LH

NOTICE:
·

Avoid touching the piston rod as much as possible to prevent foreign matter from attaching to it. Be sure to hold the cylinder while servicing.

·

Do not wear cotton gloves or other similar materials when handling the piston rod. Fibers may attach to the rod and result in gas leaks.

·

In order to prevent the piston rod from deforming, do not apply any horizontal load to the hood support.



a.

When reusing the hood support assembly:

i.
B238470

Install the 2 stop rings to the hood support assembly.



b.
B238471

Install the hood support assembly.

NOTICE:

Install the hood support assembly while supporting the hood by hand.



c.

Check that the hood support assembly is connected to the ball joint and cannot be pulled off.