Home › Vehicle Exterior › WIPER / WASHER › WIPER AND WASHER SYSTEM
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261257 WIPER AND WASHER SYSTEM J

WIPER / WASHER  WIPER AND WASHER SYSTEM  Washer Signal Circuit  


DESCRIPTION

The headlight cleaner control relay receives the windshield washer operation signal.

WIRING DIAGRAM

B246536E01
5.461,0.935 5.905,1.096 0.443,0.160 10 FRWA 5.251,0.823 5.361,0.984 0.110,0.160 10 5 0.729,0.926 2.159,1.269 1.430,0.343 10 from Windshield Wiper Switch Assembly 4.96,1.836 6.984,2.187 2.024,0.350 10 A38 Headlight Cleaner Control Relay

PROCEDURE

1.CHECK OPERATION
a.

Check the operation of the front wiper and washer system (See page Vehicle Exterior>WIPER / WASHER>WIPER AND WASHER SYSTEM>SYSTEM DESCRIPTION).

OK:

Front wiper and washer system operates normally.




OK

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)

NG

2.CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER SWITCH ASSEMBLY - HEADLIGHT CLEANER CONTROL RELAY)
a.
U170627E01
0.177,0.068 0.338,0.233 0.161,0.165 10 *a 1.967,1.698 2.427,1.850 0.460,0.151 10 FRWA 1.711,1.299 1.823,1.792 1.823,1.792 1.943,1.792 false 0.501,1.056 0.794,1.203 0.292,0.147 10 A38

Disconnect the A38 headlight cleaner control relay connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
A38-5 (FRWA) - Body ground Ignition switch ON, front washer switch on Below 1 V
A38-5 (FRWA) - Body ground Ignition switch ON, and front washer switch off 11 to 14 V


Text in Illustration
*a Front view of wire harness connector
(to Headlight Cleaner Control Relay)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR