Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261262 WIPER SWITCH A

WIPER / WASHER  WIPER SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
·

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).

·

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).



Hide 45287 2.REMOVE LOWER STEERING COLUMN COVER

a.
E198970

Turn the steering wheel to the left as necessary to remove the screw.


b.
E198974

Turn the steering wheel to the right as necessary to remove the screw.


c.
E202443

for Power Tilt and Power Telescopic:

i.

Remove the screw.



d.
B243928

Detach the 2 claws and remove the lower steering column cover.


Hide 45286B 3.REMOVE UPPER STEERING COLUMN COVER

a.
E202160

Detach the 4 clips and claw to remove the upper steering column cover.


Hide 84650 4.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

a.
E202158

w/ Rain Sensor:

Disconnect the connector.


b.
E202159

w/o Rain Sensor:

Disconnect the 2 connectors.


c.

Detach the claw and remove the windshield wiper switch assembly.