Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261270 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  INSTALLATION  


PROCEDURE

Hide 89944 1.INSTALL RAIN SENSOR TAPE

NOTICE:

The rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.


a.

Clean the rain sensor sensing portion with a piece of cloth, etc.


b.
E179754E01
1.41,3.202 1.610,3.376 0.201,0.174 10 B 0.509,2.222 0.710,2.396 0.201,0.174 10 A 0.898,1.161 1.084,1.321 0.186,0.160 10 *1 1.108,1.246 1.562,1.409 false

Peel off the smaller release sheet, and then attach the rain sensor tape on the rain sensor sensing portion as shown in the illustration.

Standard:
Area Measurement
A 13.5 mm (0.532 in.)
B 7.5 mm (0.295 in.)


Text in Illustration
*1 Rain Sensor Tape

NOTICE:

Use your fingers to push out any air bubbles from under the tape.



Hide 89941 2.INSTALL RAIN SENSOR

a.

Clean the windshield glass with a piece of cloth, etc.

NOTICE:
·

Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

·

If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.




b.

When installing a new rain sensor or replacing the rain sensor tape:

i.

Peel off the release sheet.

HINT:

Do not touch the silicon coated surfaces.



ii.
E182986E07
0.969,1.531 1.115,1.531 1.115,1.531 1.26,1.615 false 1.135,0.875 1.448,1.073 false 0.896,0.865 1.146,0.865 1.146,0.865 1.875,0.771 false 0.792,1.438 1.021,1.635 0.229,0.198 10 false *1 2.385,1.688 2.646,1.938 0.26,0.25 10 false (1) 1.26,1.885 1.625,2.135 0.365,0.25 10 false (2) 0.74,0.771 0.979,1.01 0.24,0.24 10 false *2

Attach the 2 guides, and then carefully install the rain sensor to the glass surface so that there are no air bubbles from forming between the contact surfaces.

Text in Illustration
*1 Stopper
*2 Guide

NOTICE:

Do not touch the silicon coated or glass surfaces.



iii.

Push in the stopper.


iv.

Connect the connector.



Hide 89943 3.INSTALL RAIN SENSOR COVER

a.

Attach the 2 claws to install the rain sensor cover.