Home › Vehicle Exterior › WIPER / WASHER › RELAY (w/ Headlight Cleaner System)
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261271 RELAY(w/ Headlight Cleaner System) G

WIPER / WASHER  RELAY(w/ Headlight Cleaner System)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 85942 1.INSPECT HEADLIGHT CLEANER CONTROL RELAY

a.
E186708E03
0.615,1.61 0.827,1.773 0.211,0.163 10 PB 0.615,0.46 0.789,0.623 0.173,0.163 10 IG 1.747,0.108 1.868,0.271 0.121,0.163 10 H 2.434,1.61 2.555,1.773 0.121,0.163 10 E 0.878,1.639 1.239,1.398 false 2.031,1.375 2.392,1.615 false 1.261,0.769 0.9,0.529 false 1.616,0.769 1.616,0.188 1.616,0.188 1.696,0.188 false 2.533,0.751 2.935,0.932 0.403,0.181 10 HDLO 2.078,0.919 2.537,0.848 false 1.432,1.732 1.858,1.914 0.426,0.181 10 FRWA 1.665,1.455 1.662,1.743 false 0.057,0 0.327,0.209 0.270,0.209 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 (PB) - 4 (E) Battery voltage not applied 10 kΩ or higher
Battery positive (+) → Terminal 3 (IG)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 2 (H)
Battery negative (-) → Terminal 4 (E)
Below 1 Ω for 0.8 to 0.9 seconds, then resistance increases by large amount
Battery positive (+) → Terminal 3 (IG)
Battery positive (+) → Terminal 1 (HDLO)
Battery negative (-) → Terminal 4 (E)
Battery negative (-) → Terminal 5 (FRWA)


If the result is not as specified, replace the headlight cleaner control relay.

Text in Illustration
*a Component without harness connected
(Headlight Cleaner Control Relay)