Home › Vehicle Exterior › WIPER / WASHER › HEADLIGHT CLEANER SWITCH › 2015.06–2017.08
RM27T0E _59 Vehicle Exterior _053746 WIPER / WASHER _0261272 HEADLIGHT CLEANER SWITCH G

WIPER / WASHER  HEADLIGHT CLEANER SWITCH  INSPECTION  


PROCEDURE

Hide 84150D 1.INSPECT HEADLIGHT CLEANER SWITCH ASSEMBLY

E204130E02
0.036,0 0.338,0.246 0.302,0.246 10 *a 1.113,1.652 1.438,1.829 0.325,0.177 10 ILL+ 2.089,1.649 2.386,1.826 0.297,0.177 10 ILL- 1.624,1.256 1.236,1.643 false 1.833,1.254 2.199,1.62 false

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
5 - 8 Headlight cleaner switch on Below 1 Ω
Headlight cleaner switch off 10 kΩ or higher



b.

Connect the positive (+) lead of the battery to terminal 7 (ILL+) and the negative (-) lead to terminal 6 (ILL-).


c.

Check that the headlight cleaner switch assembly illumination comes on.

OK:

The headlight cleaner switch assembly illumination comes on.


If the result is not as specified, replace the headlight cleaner switch assembly.

Text in Illustration
*a Component without harness connected
(Headlight Cleaner Switch Assembly)